Installing and Using my ErgoUp | Quick Guide for ErgoUp Products
Quick Guide to Installing and Using your ErgoUp Leg Rest
Installing your new ErgoUP leg rest is super easy! It comes fully assembled for your convenience and will attach to almost any regular, single post office chair. If you have questions about your particular chair, please contact us at firstname.lastname@example.org before ordering.
NOTE: If the base of your chair is like a pyramid, the ErgoUP will not work properly.
Step One: Preparing Your Chair
Most office chairs have a telescopic plastic sleeve that covers the main chair cylinder. Normally there are three sections. You must slide the bottom section up so that it exposes the chair cylinder. This is where the leg support attaches to the chair.
Step Two: Attaching The ErgoUP to Your Chair
Open the Velcro tie strap attached to your ErgoUP, leaving it threaded through the support adapter. Now wrap the strap around the cylinder and through the “D” ring. The D-ring is chrome metal component on the strap. When the strap is through the D-ring pull it tight and press the Velcro pieces together. The leg support is now ready to adjust to fit you.
Step Three: Adjusting The Leg Rest
Set the distance by moving the back edge of the pad so that it is directly behind your knee. You can make this adjustment by using the horizontal adjustment. The final setting is the height. It is recommended the height is set so that the knee is comfortable and does not raise your leg off the seat of the chair. Always follow your doctor or safety consultant's recommendations for proper support first.
Pad Rotation: Floats to match leg angle.
Pad height adjusts: 14" - 24"
Pad distance from chair adjusts: 16" - 26"